REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Kia Clarus (1995 issue)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Kia
	Clarus
		Maintenance
		Engines FE DOHC and DOHC T8
		Greasing system
		Cooling
		The power supply system and release
		Fuel system
		Ignition system
		Coupling
		Manual transmission
		ACP G4A-EL
			Technical data
			Search and definition of malfunctions
			The table of fast diagnostics
			Self-diagnostic system
			Fault codes
			Diagnostic connector
			Cleanup operation
			Testing of teamwork of an automatic transmission and the engine for the motionless car
			Testing time lag
			Testing of pressure transmission fluid
			Testing for the pressure reduced by the valve
			Check of level and a liquid condition in an automatic transmission
			Leaks of a liquid from an automatic transmission
			The accelerator cable
			Mode Switch
			Brake light switch
			The temperature sensor Transmission Fluid ATF
			Check the resistance of the pulse generator
			Solenoid valves
			Removal of an automatic transmission
			The general recommendations about transmission dismantling
			Dismantling of an automatic transmission
			Check and adjustment of preliminary loading of bearings
			Assembling automatic transmission
			Installation of an automatic transmission
			Oil radiator
			Disk Drive
			Check of work and adjustment of position of the selector lever
			Lever
			Repair of the selector lever
		AKP 50-40 LE
		Axes and power shafts
		Steering
		Wheels and tires
		Suspension
		Body
		The air conditioning system
		Electrical equipment
		Brakes
		Electric schemes

Check of work and adjustment of position of the selector lever

Check

PERFORMANCE ORDER

	1. Make sure that the selector lever can be moved, as shown in the figure.
2. Make sure that you move the selector lever from position P to position L, in every state there is a click.
3. Make sure that the selector lever position indication correspond to the selector lever.
4. At discrepancy adjust the characteristics of the display panel.
5. Make sure that the selector lever position match display in the instrument cluster.
6. At discrepancy adjust the characteristics of the switch.
7. Make sure that the car operates in each selected position.

Adjustment

PERFORMANCE ORDER

1. Move the selector lever to position P.
2. Loosen the screws selector lever cable.
3. Pull the selector lever to him.
4. Click on the selector lever against the position P and hold it in this position.
	5. Tighten the selector lever cable. The inhaling moment: 7,9-10,7 N ??? m

Display panel

PERFORMANCE ORDER

1. Move the selector lever to position P.
2. Loosen the screws that secure the display panel.
	3. Align the screw holes in the slider in the display panel. Install a suitable thick wire for supporting the slider.
4. Temporarily set the display panel bracket to the selector lever.
	5. Tighten the screws that secure the display panel in the sequence shown in the figure. Tightening torque: 2.0-2.9 N ??? m
6. Remove the wire.
7. Make sure that the selector lever position display panel correspond to the selector lever in each position.

« previos page
Disk Drive

next page »
Lever