 printable version
Colouring
To avoid problems with the color, apply the color applied to the "Primer" by the same manufacturer as the aerosol paint. Otherwise, the paint will bubble and wrinkle.  | It is recommended to try a paint on any suitable metal, such as old wing. |
| - To paint color space should be dry and dusty. If possible, blow compressed air.
- To moisten the floor dust.
- Clean the repair area with the surrounding surface of the silicone remover Even better adhesion of paint will provide wiping the cleaning surface Silicone-free polishing paste.
- Before use, shake strongly for 2-3 minutes aerosol containers of paint, otherwise the metal will form streaks of paint.
- When applying the varnish Metallic sprinkle a little paint on the cardboard to remove the deposited metal particles in the tube.
 | - Large areas, both horizontal and vertical are covered by the "procession": Begin painting is painted area and also change the direction of the outside surface of the cone coloring.
|
- Small spray surface in a spiral from the outside inwards, to eliminate unnecessary large cloud of paint.
- Aerosol packaging to maintain a constant speed and the same distance from the painted surface. The correct distance of about 25 cm.
- If you want to ensure as far as possible without any noticeable transition coating intact paint: It is best to manage if the color to hold at least four passes. At each subsequent pass to expand the application of paint for two to three centimeters.
| If the stain is conducted at very close range or movement is too slow or has a variable speed, the so-called nodules occur paint. This means that in some places there is dripping ink, as there for one time accumulated too much paint. The same happens when the reversal is performed on the painted surface. |
- The process of color repeat with about 5-minute breaks to volatilize the solvent as long as a coat of paint will not be enough. Varnish Metallic paint between passes with constant shaking to the metal particles are not settled.
| When painting Metallic paint is very difficult to get a color match. Pigmentation (distribution of aluminum particles) occurs best when sprayed from a distance of 25 and 30 cm. There are techniques to equalize colors: Slow movement of the arm and thus more fat lacquer gives a darker tone, but with the rapid coating of varnish seems lighter. |
- When painting the paint Metallic Metallic base coat of varnish is covered with varnish, and only then paint Metallic gets its characteristic luster. Coating is also made with a thin layer of three or four passes with a rest pauses in a few minutes. Before the first pass compactor varnish should not less than thirty minutes to erode. Clearcoat must cover the surface is not less than the width of the palm, which respectively move in advance the protective paper.
- To empty aerosol containers, which turn it up and sprinkle the total yield of paint.
- Immediately after painting remove the protective paper. If this is not done, got on paper paint can penetrate the surface of the body.
- Dry the painted surface. The drying process can be accelerated by drying or strong Photolamps.
| Do not use a heater with a fan, with the rising dust particles deposited on the fresh paint. |
- After drying, through no less than 48 hours, carefully remove the coating of paint from the border with a soft polishing tool. At the same polish on the longitudinal dimension of the vehicle.
|
|
|
