|
printable version
Removing and installing side moldings
Withdrawal Setting | - Clean the glue on the back of gasoline. If the new molding, remove the protective film starred places.
| - If you set back the old molding, wash off the glue and gasoline apply double-sided tape.
|
|
|
(9 / 85-9 / 89 MY.). | | - Mark the installation position of masking tape on the body molding.
|
- Heat molding the body around to + 40 ?� - + 80 ?� C.
- Snap each key stroke the palm.
|
|
. With 10/89 vol. | | - Primed molding in designated areas.
|
| - Stick to the shaded place double-sided adhesive tape. On the inside of the applied polyurethane adhesive.
|
|
|
|
|