 printable version
Removing and installing door trim
 | Described for the removal of the front door. Removal of rear door should be made accordingly. |
Withdrawal | - Disconnect earth cable from the battery.
| This data is erased from the memory of malfunctions of the engine or a protective code of a radio receiver. Before disconnecting the battery should read instructions in Section Removal and installation of the battery. |
- When manually adjusting the mirror, unscrew the drive arm after removing the cover with a small screwdriver, see chap. Wheels and tires, a body, car coloring, care of the car.
- Remove trim Triangle door.
 | - Since 3/91 MY .: Remove the trim button, the door latch with a small screwdriver and remove with antistatic button. To avoid damaging the upholstery, put a screwdriver under the piece of cardboard.
|
 | Antistatic button connected to the metallic mass member. Through the touch of a button before going out, you can avoid electric shock, static charge. |
 | - Remove the window handle. To do this, insert a screwdriver or a piece of cloth between the spacers and the handle and press the retainer. Simultaneously, remove the handle from the shaft. If the handle is not reached, the retainer can be removed a bent wire.
|
- Unscrew the inner door handle and pull on the drive rod.
- Unscrew the door trim and remove it. Disconnect switch on the electric control mirror.
- Squeeze door trim frame from the wide polymer or wooden wedge. This button is released from the mounting grips. Remove the upholstery.
- If necessary, remove the sealing film from the door at the same time as possible not to tear it.
|
|
Setting |  | - Careful sealing film pasted to the frame upwards. The film serves to isolate the passenger compartment from drafts, noise and water ingress. When the adhesive layer is not good enough to use double-sided adhesive tape. Break the film to stick with adhesive tape. With a significant gap replace film.
|
- Check button fastening door trim. Damaged or bent Replace button.
- If available, connect the cable of an external mirror.
- Install the door trim from the top first, then insert the bottom and in the field of secure fastening buttons blows back of the hand.
- Screw the door trim.
- Insert and secure the inside door handle.
- Push the handle window with inserted retaining clip on the shaft so that when the window is closed the handle was located as well as on the opposite door.
- When manually adjusting the mirror to screw the drive arm, then install the cover screws, see. Chapter Wheels and tires, a body, car coloring, care of the car.
- Install door trim triangle.
- C3 / 91 MY .: to press and engage in upholstery trim button locking the door with antistatic button.
- Connect the earth cable to the battery.
- If available, set the clock and set the security code radio.
|
|
|
