 printable version
Cable Throttle (DB)
GAS ENGINE
A warning  Cable throttle is very sensitive to bending and, therefore, the installation must be handled especially carefully. The only slight bend may cause it to break later in the manual. Therefore, the curved cables should not be used during installation.
Withdrawal
| PERFORMANCE ORDER | | 1. Remove the guide element (30/5). In this first stretch of a plastic nipple. | | 2. Unhook the cable (30) throttle. For this output through the slot in the rocker lever (32/6) cable drive. Squeeze the plastic spring clip (30/4) and pull the cable on the support (32/3). | | 3. Remove the protective cover under the control panel. | | 4. Unhook the cable mount the drive on the throttle lever. To do this, pull the holder with spacers. | | 5. Squeeze the outside from the interior of the vehicle throttle cable. It does not push the rubber grommet. | | 6. Complete, remove the throttle cable. |
|
Setting | PERFORMANCE ORDER | | 1. Apply anti-corrosion grease Mercedes-000989 87 5110 throttle cable between the guide element and tip. | | 2. Check the rubber sleeve for damage and porosity, otherwise replace it. | | 3. Draw into the interior of the vehicle throttle cable and hook it on the lever of the accelerator pedal. | | 4. Assemble the protective shield under the control panel. | | 5. Enter through the hole in the support wire throttle control, push it into the support and secure. | | 6. Hang with wire guiding element throttle. Pay attention to the plastic nipple was registered in the guide member. | | 7. Adjust the throttle cable. |
|
|
