REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Mercedes-Benz C-Class (from 1993 to 2000, the year of issue)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Mercedes-Benz
	C-class
		Introduction
		Maintenance
		Engines
		Lubrication system
		Cooling
		Heating and ventilation
		Ignition system
		Fuel system
			Fuel System Description
				Introduction
				Fuel tank
				Fuel Level Sensor
				Fuel pump
				Fuel filter
				Air filter
				The transverse tube of the air filter
				Intake manifold
				Throttle cable / throttle lever (DB)
				Cable Throttle (DB)
				The contour of the diesel engine fuel
				Preheating diesel
				Fuel thermostat
				Hydraulic valve housing
				Throttle cable / throttle lever (DD)
				Cable Throttle (DD)
			PETROL INJECTION
			The injection system of diesel engines and power
			EXHAUST
			Transmission
			Manual and automatic gearbox
		Chassis
		Steering
		Brakes
		Body
		Electrical

printable version

Fuel filter

GAS ENGINE

Withdrawal

A warning

Be sure to pay attention to good ventilation of the workplace. Fuel vapors are poisonous, avoid the use of open fire because of the danger of fire!

Fuel filter as viewed in the direction of motion, is located on the underside of the vehicle to the right front of the rear axle.

PERFORMANCE ORDER

1. Disconnect from the terminals of the battery ground cable (-). A warning This erased anti-theft radio code.
2. Reduce the vapor pressure of the fuel, which briefly open the filler cap of the fuel tank.
3. Remove the protective cover (69), previously having marked its installation position.
	4. Remove the clips from the inlet (53) and discharge (52) pipes with standard hose clamps (011). For ease of assembly, label the tubes with adhesive tape.
5. Remove the fuel filter on the banjo bolt (59). Remains of spilled fuel, wipe with a cloth.
6. Remove the filter pressure fuel.
	7. Loosen the bolts (arrows) on the holder and remove the fuel filter (55).

Setting

PERFORMANCE ORDER

1. Check for damage to the plastic sleeve (56a) or a plastic film (56) and replace if necessary.

2. Install the fuel filter with a plastic sleeve or film. Plastic sleeve have to be installed between the fuel pump and the holder. Pay attention to the fact that it is performed on both sides of the holder. Otherwise, the direct contact with the fuel filter holder can occur contact corrosion of metals. Secure the fuel filter bracket bolts (57/1) (57/3).

3. Screw the fuel hoses. Insert banjo bolt with new copper sealing ring and tighten to 25 Nm

4. Remove hose clamps.

5. Replace the protective cover (69).

6. Connect the battery ground cable (-).

7. Start the engine and the engine running, check the tightness of the connection points.

8. Set the clock.

9. Enter the anti-theft code for the radio.

« previos page
Fuel pump

next page »
Air filter