printable version
High-voltage wires Checking and replacing
1. The state of high-voltage wires checked without fail when replacing spark plugs with new ones. 2. High-voltage wires should be inspected individually. 3. Carefully remove the wire from the spark plug (see. Above). 4. Inspect the inside of the tip and check for corrosion in a clear powder coating. Check the fit of the tip to the spark, if necessary, turn in the collet chuck. 5. Gently wipe the entire length of wire with a clean cloth, removing all dirt and oil deposits, check the wires. 6. Disconnect the ignition distributor cap, pulling the rubber boot. Check for corrosion and a perfect seal wires, put the wires in place. 7. If necessary, replace the wires in the kit (commercially available ready-wire selected lengths defined tips).
|