add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Nissan Terrano II (from 1985 to 1999 model year)

general info. full specifications. diagnostics. hints. tips. tricks
Nissan Terrano 2
Home
 
Nissan
Terrano 2
Operation and Maintenance
Maintenance Vehicle
The four-cylinder engine
Overview
Types of repair work carried out without dismantling the engine from the car
The order of installation of the piston of 1st cylinder at top dead center of the compression stroke.
Head cover - removal and installation
Roller rocker arms -snyatie and installation
Roller rocker arms - disassembly and reassembly
Camshaft - removal and installation
Camshaft, bearings and rocker - check
Valve springs and valve seals - Replacement
Intake manifold and installation -snyatie
Exhaust Manifold and installation -snyatie
Cylinder head - removal
Cylinder head - set
Oil pump - removal and installation
Oil pump - checking
Crankshaft pulley - removal and installation
Front crankshaft oil seal - replacement
Front cover - removal and installation
Chain and sprockets - removal and installation
Sump - removal and installation
A flywheel (a leading disk of the torque converter) and installation -snyatie
The rear oil seal - replacement
Engine support - replacement
Engines VS
All engines
Systems of cooling, heating, ventilation and air conditioning
Fuel and an exhaust system
The system of electric motor
Emission of exhaust gases
Manual transmission
Automatic Transmission
Coupling the propeller shaft and rear axle
Chassis car with wheel formula 4x4
Brakes
Suspension and steering
Body and trims
Electrical system
 


Hit Counter by Digits


print page printable version

Roller rocker arms -snyatie and installation



1. Remove the cylinder head cover.
2. The roller rocker arms attached to the head 10 by bolts. Loosen the screws by 1/4 turn, in order from the center to the periphery. Remove the bolts but do not remove.
3. Remove roller rocker arms.
4. If the rocker will not be charged, leave in place 4 outer bolts (otherwise decomposes build-exists). If the rocker will be removed for repair, refer to the description in section 6.
5. When installing tighten the screws by hand and tighten with the set moment, making 1/4 turn for the reception.




« previos page
Head cover - removal and installation
next page »
Roller rocker arms - disassembly and reassembly

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.