add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Nissan Terrano II (from 1985 to 1999 model year)

general info. full specifications. diagnostics. hints. tips. tricks
Nissan Terrano 2
Home
 
Nissan
Terrano 2
Operation and Maintenance
Maintenance Vehicle
The four-cylinder engine
Overview
Types of repair work carried out without dismantling the engine from the car
The order of installation of the piston of 1st cylinder at top dead center of the compression stroke.
Head cover - removal and installation
Roller rocker arms -snyatie and installation
Roller rocker arms - disassembly and reassembly
Camshaft - removal and installation
Camshaft, bearings and rocker - check
Valve springs and valve seals - Replacement
Intake manifold and installation -snyatie
Exhaust Manifold and installation -snyatie
Cylinder head - removal
Cylinder head - set
Oil pump - removal and installation
Oil pump - checking
Crankshaft pulley - removal and installation
Front crankshaft oil seal - replacement
Front cover - removal and installation
Chain and sprockets - removal and installation
Sump - removal and installation
A flywheel (a leading disk of the torque converter) and installation -snyatie
The rear oil seal - replacement
Engine support - replacement
Engines VS
All engines
Systems of cooling, heating, ventilation and air conditioning
Fuel and an exhaust system
The system of electric motor
Emission of exhaust gases
Manual transmission
Automatic Transmission
Coupling the propeller shaft and rear axle
Chassis car with wheel formula 4x4
Brakes
Suspension and steering
Body and trims
Electrical system
 


Hit Counter by Digits


print page printable version

Types of repair work carried out without dismantling the engine from the car



It can be replaced without dismantling the suction pads and exhaust manifold, oil pan gasket, cylinder head, crankshaft oil. You can rent these units as the intake and exhaust manifolds, oil pan, oil pump, water pump, starter, alternator, distributor, details of the timing, fuel system assemblies and cylinder head. In extreme cases, when there is no necessary equipment, without removal of the engine can be replaced by the piston rings, pistons, connecting rods and connecting rod bearings. However, to carry out this work without dismantling and complete disassembly of the engine is not recommended, as it requires treatment related components, as well as preparatory activities for the assembly.




« previos page
Overview
next page »
The order of installation of the piston of 1st cylinder at top dead center of the compression stroke.

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.