| 1. To access the battery, open the cover. |
| 2. The level of the electrolyte must always be between the MIN and MAX deposited on the longitudinal sides of the battery. |
3. By reducing the electrolyte level should be in the respective banks add distilled water up to the MAX. |
| 4. Average closed stopper Battery fuse holder. On both sides, as indicated by the arrow, tighten the fuse holder cover and tilt it to the side. |
5. Unscrew and remove the battery negative lead (1 cm. Fig. Location of the fuses on the battery). |
6. Loosen the positive wire. |
7. Fold the front first and then the rear clamp from the battery terminal. To do this, squeeze out a few clips from the battery. |
8. Remove the top fuse holder together with the positive wire from the battery. |
9. Remove the stopper and add distilled water in the battery banks. |
10. Do not fill higher than necessary, because otherwise the electrolyte will leak through the air vent. This can result in damage to paint and corrosion resistance of the body. |
11. After adding the electrolyte to be tightly related storage jars stoppers. |