printable version

Removal and installation of the door bracket

On the arm is mounted door lock doors, windows, and a speaker.

If necessary, replace the power windows must be replaced with the bracket.

Withdrawal

PERFORMANCE ORDER

1. Mount the door can be removed only when the glass door is not fixed into place window. To do this, dip the glass doors to the level of technological holes in the bracket and release it. 2. Remove the inside front door trim. 3. Remove the front door lock cylinder. 4. Remove the technological plug (1) from the bracket of the front door (2 - a bolt, arrows indicate the location of the screw mounting bracket to the door with the units.). 5. Lower the glass door so as to allow access to the bolts fastening the glass. Loosen the bolts (2) and loosen the clamps that secure the glass door. 6. Move the glass door all the way up and, using adhesive tape, fix it in this position. 7. Disconnect all the electrical connectors in the front door (arrows). 8. At the end of the front door, unscrew the two screws (2) securing the door lock (1 - the bolt of the lock cylinder, 3 - cap). 9. Remove the screws that secure the bracket to the front door. 10. Separate the top part of the bracket from the door, then lift the bracket and moving it to the door hinge, remove the door. 11. Turn the bracket and disconnect the electrical connector from the door lock. 12. On the back side of the bracket release clamps that secure the electrical wires.

Setting

PERFORMANCE ORDER

1. In the sequence, return to removal, install the bracket in the front door. 2. Screw the mounting bracket bolts and tighten to 8 Nm in the sequence (A - glass doors in - screw fastening clamp glass). 3. Remove the tape holding the glass door in the top position, move the window back to the rail, secure it into place and tighten the screw (B) to 10 Nm. 4. The further installation is made in sequence, return to removal.