printable version
Removal and installation of the lock of a back door
Details of the lock of a back door
1 - safety bracket; 2 - handle; 3 - bolt actuating motor Central locking; 4 - the executive engine lock central administration; 5 - draft; | 6 - screw Torx; 7 - traction control; 8 - the case of the lock cylinder; 9 - lock; 10 - a bolt with spherical countersunk screws, 20 Nm; 11 - the lever |
Withdrawal
PERFORMANCE ORDER | 1. Remove the lower rear door trim. | 2. Remove the handle rod (5), safety bracket (1) and the housing of the lock cylinder. | 3. Disconnect the electrical connector from the backlight luggage. | 4. If necessary, remove spring clamp traction control central locking control. | 5. Remove the Torx screws and remove the handle. | 6. Disconnect the spring clamp actuator rod (7), unscrew the bolts (10) and remove the lock on the rear door. |
|
Setting
PERFORMANCE ORDER | 1. Set the lock and secure it with screws. | 2. Supporting the lever (11), set to a control rod (7). | 3. The further installation is made in sequence, return to removal. |
|
|