- Changing the transmission oil must be carried out in strict accordance with the schedule of routine maintenance of the car (see. Section routine maintenance schedule).
- Prepare a fresh supply of the required grade of transmission oil, drain capacity suitable volume, wrench and the appropriate size of clean rags / old newspapers.
- The oil must be collected, as a pre-heated during a short trip up to normal operating temperature - hot oil has a higher turnover and better washes away the sludge and other deposits. Warm the gearbox, driving the car on the overpass / post horizontally on the lift.
- Remove the filler / level plug Manual transmission housing (see. Section Checking the oil level).
- Remove the bottom of the sump box drain plug and drain the oil into the prepared container.
- After the oil leak stops, clean the drain plug, screw it on the regular place and tighten to the required torque (30 Nm), - do not forget to replace the washer.
- Filling fresh gear oil is produced through control / filler opening (see. Section Checking the oil level).
 | Each manufacturer uses in the manufacture of oil-based and own basic supplements - do not mix oils of different manufacturers! |
- Take a short trip by car, after which check the drain and filler / level plug Manual transmission housing for signs of leakage.
|
|
