Replacing the grease transfer case and differentials
Transfer case
PERFORMANCE ORDER
Poddomkratte car and establish it on props.
Get under the transfer case assembly suitable drain capacity of not less than 2 liters.
Remove the oil filler / control (see. Section Checking the oil level) and the drain plug - drain hole located at the bottom of the crankcase - and drain the oil from the transfer case into the prepared container.
Replacing the washer, screw the drain plug and tighten it with a force of 30 Nm.
Filling in a box of fresh oil is produced through control / filler opening (see. Section Checking the oil level).
Differentials
The procedure is similar to the procedures given above for the transfer case.Tightening torque drain plugs, as well as jellied / control account for 39 ÷ 54 Nm - do not forget to change the sealing washers.