|
|
 printable version
Removing and installing control arm / replacement of a rubber support
Since the tightening rubber mounts car should stand on wheels, you need a lift or a platform or a viewing hole. Withdrawal  | Lubricate (Lithium universal grease) |
| - Mark the position of the disc relative to the wheel hub to balance the wheel can be installed in the same position.
- Loosen the nut of the front wheels of the car standing on the ground.
- Raise the vehicle.
- Remove the front wheels.
- Loosen the stabilizer support to the wishbone, which unscrew the nut and remove the bolt -1- -3- to intermediate elements -2-. On vehicles to 9/89 MY. and all models of "universal" bolt in contrast image is set from the top down.
- -4- Unscrew a bolt on the front of the support arm.
- Loosen the clamp at the rear of the support arm (bolt -5-).
- Loosen the nut -6, -6 to remove the bolt on the knuckle. Remove the pin of the ball joint from the steering knuckle down and remove the lever.
 | If the pin of the ball joint can not be removed by hand, insert a pry bar between the hinge and swivel. Without damaging the collar joint, put a rag. |
|
|
Setting | - Check the wear of bearings and knuckle arm and replace if necessary. See Chapter Checking / replacing the support arm / knuckle.
- Insert the wishbone on the body and the knuckle, tighten bolts and nuts by hand until tightening.
- Screw the regulator, without tightening the screws completely.
- Screw the wheel, given labels put at removal. Lower the car and tighten the wheel nuts crosswise with torque of 100 Nm.
- Several times to swing the car settled to wheel suspension.
 | - Models up to 9/89 MY. and models of "universal": Screw the nut stabilizer until the length of serving thread becomes equal to 10.8 mm.
|
 | - Models with a 10/89 vol., Except for "universal": Screw the nut stabilizer until the protruding length of the thread will not be in the range 17 - 19 mm.
|
- Tighten the front and rear support arm with a force of 110 Nm, the bolt on the steering knuckle with a force of 60 Nm.
- As soon as possible to measure the angles of the wheels in the workshop.
|
|
|
|
