printable version

Introduction

Thoroughly clean the joints and their surroundings before their separation.

Lay the removed parts on a clean surface and cover them. Use film or paper. Do not use cloth nappies!

Carefully cover the mounting parts or cover them with a turnkey basis, if the repairs will be carried out any time soon.

Just before the assembly remove the spare parts from the packaging. Install only clean parts.

Do not use parts that are stored unpackaged (eg, tool box and so on. N.).

When you open the fuel system, if possible, do not use compressed air. Try not to move the car.

Draining and refueling

Be sure to pay attention to good ventilation of the workplace. Fuel vapors are poisonous, avoid the use of open fire because of the danger of fire!

PERFORMANCE ORDER

1. In addition, make a return journey due to the existing fuel in the tank. 2. Disconnect the battery ground cable (-). A warning This erased anti-theft radio code. 3. Lift the car. 4. Reduce the pressure of the fuel vapor. To do this, briefly open the filler cap of the fuel tank. 5. Remove the protective cover from the fuel level sensor. Pay attention to not pinch the electrical wires or the hose to drain the fuel. 6. Remove the plug from the fuel level sensor. 7. Remove the oil drain valve. 8. Screw the drain hose with shut-off valve in the drain valve. 9. Open the fuel filler, open the shut-off valve and drain the fuel into a suitable container. 10. Remove the drain hose and tighten the drain plug with a torque of 15 Nm Pre-check for damaged O-ring, if necessary, replace it. 11. Push the plug on the fuel gauge, mount guard. 12. Lower the car (remove the jack). 13. Fill the fuel through the filler pipe. Pay attention to the fuel tank do not hit the dirt particles. 14. Close the fuel tank cap. 15. Connect the battery earth cable. Set the time. Enter anti-theft code for the radio. 16. Start the engine and check the tightness of all connections.