 printable version
Service valves
Given the complexity of the nature of work and the need for special equipment, performance of service valves, their guides and seats would be the right thing to entrust the service center personnel.
On their own car owner may be made procedures such as disassembling the head, the primary cleaning and checking the status of the valve train components. This is usually made sufficiently clear idea of the amount of work to be performed and can be prepared a sample list of necessary replacement components. Then head should collect and deliver professional service in a workshop service centers.
Experts workshop will be removed from the valve head and valve springs and will make necessary regenerative repair or replace worn components (valves, their saddles, guides, springs, plates of springs and crackers of cutting locks). Compulsory replacing stem seals. After assembly, the components will be tested installation height of the valve springs. If necessary, experts will bore head to restore the flatness of its mating surfaces.
After completion of the repair professional head her condition usually corresponds to the new one. Before installing the motor do not be lazy once again thoroughly clean the head, completely removed from all its cavities and channels metal sawdust, traces of grit and other small industrial waste. All channels and apertures blow compressed air (do not forget to wear safety goggles).
|
