printable version
Circuit breakers - the general information
Circuit breakers are used to protect these components onboard electric equipment as headlamps and electric motors drive windows / cover of the top hatch / door locks, etc.
On some models, after tripping circuit breakers are reset automatically. If the cause tripping the breaker overload wore not sporadic, you should immediately check the status of the corresponding loop. After a fault, the circuit breaker re-enters the normal mode of operation. Sometimes Returns breaker in operation has to be done manually after the cause of the overload.
For the introduction of the chopper in the operation, disconnect the negative cable from the battery.
| If installed on the car stereo is equipped with a security code before to disconnect the battery make sure that have a correct combination for audiosystem input in action! |
Remove the chopper, insert a thin rod in a specially provided opening in the housing and push it into the hole until it clicks. Then it makes sense to use an ohmmeter make sure available conductivity between the terminals of the breaker, and only then install it in place.
|