printable version
Replacing bulbs
| Flasks lamps remain hot for a further 20 minutes after turning off lighting. Before starting work, make sure that the components have cooled down completely. |
Front side lights / direction indicators | 1. Poddomkratte car and establish it on props.
| 2. Access to assemblies indicators and marker lights offer below. |
3. Holder marker light is removed by pulling out of its landing slot. Cartridge Indicator is necessary to also rotate. To remove the bulb from the socket it is necessary to press and turn counterclockwise. |
|
Side marker lights | | 1. Open the hood, remove the screw located near the housing block head lights, then shook the assembly side marker light (on models of early years of release - indicator lights). Pull the assembly out strongly and release it from the body panel. |
2. Remove the bulb from the socket and replace it with a new one. |
|
The rear lights and brake lights
Lamps, located in the body of the combined lantern | 1. Open the lid of the luggage compartment. Uncover the viewing window in the interior trim panel for access to the rear combination lamp assembly. Cartridge outdoor lamps equipped with a rubber stopper. To access the parking light bulb, remove the plastic cover.
2. To remove the bulb from the socket it must press down and turn counterclockwise. |
|
Lamps, located in the premises on the lid of the luggage compartment lamp assembly | | 1. Open the lid of the luggage compartment and remove the two screws securing the plate on the rear side of the lampholder lamp assembly. |
2. To remove the bulb from the socket it must press down and turn counterclockwise. |
|
License plate light | | 1. Remove the fixing screws and remove the lens assembly with a lantern light plate. In order to ensure access to the lamp pull out the cartridge from the assembly. |
| 2. To remove the bulb, pull it straight back. |
|
|
Stoplights top level | | Press the cap lamp assembly to the right, pull it in-law and remove. Lamp just pulled out of the cartridge. |
|
|
Backlighting Interior lighting (interior, luggage compartment) | 1. To remove the lampshades navigational lights / interior lamp it should be a small screwdriver to pry. 2. To remove the navigational lights should be rotated in the cartridge. Double capped lamp ceiling lamp just pulled out of the spring-loaded contact terminals his patron. Try not to touch the lamp with bare hands - the formation of grease can greatly reduce the life of the lamp.
|
|
|