printable version
Speed control system (Tempostat) - the general data and check of serviceability of functioning
Tempostat automatically selected to maintain a cruising speed of the vehicle. Electric servomotor Tempostat located in the engine compartment and the cable is connected to the gas pedal. Among the other major components of the system include the gauge-switch of stoplights, ECU Tempostat, control switches and the vehicle speed sensor. Check the individual functions of the system requires the use of special diagnostic equipment, and its implementation is beyond the qualification of the average mechanic-fan. Below is a description of the procedures only the most common tests that identify the most common causes of failure Tempostat.
Locate the fuse Tempostat and check its condition (see. Section Fuses and fuses - general information).
Ask the assistant to squeeze out a few times a pedal of a foot brake - operation responds to the pressing of the pedal sensors, brake light switch should lead to a shutdown Tempostat.
If the brake lights do not respond to pressing of the pedal, find out the cause of failure and repeat the test serviceability of functioning Tempostat.
| Visually assess the condition of the drive cable, laid on the assembly of servo motor / amplifier Tempostat to pull the throttle. Damaged or worn, replace the cable. In case of need make adjustment of a cable, which is produced as well as the adjustment of the throttle wire (see chap. The power supply system and release). |
The basis of the functioning of the monitoring signals Tempostat put the vehicle speed sensor. The speed sensor is placed in the transmission, check the functioning of the description of its operation is given in Chapter Engine management of this manual.
Description of the main verification procedure (On / Off) switch Tempostat resulted in Section Check of serviceability of functioning and replacement of the instrument panel switches.
The switch of management of functioning Tempostat mounted on the steering wheel of the car.
To test the switch, refer to the materials section Check of serviceability of functioning and replacement of the steering column switch. Replace the faulty assembly.
| Before proceeding to the verification Tempostat make sure of serviceability of functioning of a horn, a relay in which power is supplied. |
Make car trial runs. If you eliminate the malfunction Tempostat corrections made during the failed drive to a repair shop for more detailed diagnostics systems using special equipment.
|