REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Nissan Maxima QX (1993 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Nissan
	Maxima QX
		Introduction
		Operating Instructions
		Adjustment and routine maintenance
		Engine
		System of cooling, heating
		The power supply system and release
		Electric motor
		Engine Control Systems
		Transmission
		Coupling and power shafts
		Brakes
		Suspension and steering
			general information
			Removal, check of a condition and installation of the front suspension mount assembly
			Replacing strut / coil spring assembly rack
			Removal and installation of assemblage of a rotary fist with a nave
			Removal and installation of assemblage of the front wheel bearing hub
			Removing and installing front stabilizer bar
			Removal and installation of the control lever front suspension
			Replacing the ball bearings
			Removal, check of a condition and installation of the rear suspension struts
			Removal and installation of assemblage of the rear hub with wheel bearing
			Removing and installing rear rod stabilizer bar (models 1993 and 1994 issue.)
			Removing and installing the rear suspension arm (models 1993 and 1994 issue.)
			Removal and installation of components of the rear suspension models from 1995 MY.
			Removing and installing steering wheel
			Removal and installation of tips of steering drafts
			Replacement of protective covers of the steering mechanism assembly
			Removing, dismantling and installation of the rack and pinion
			Removing and installing the steering pump
			Removal of air from a hydraulic path of system of strengthening of helm
			Replacing the wheel studs
			Wheels and tires - general information
			Wheel alignment
		Body
		Onboard electric

printable version

Removal and installation of assemblage of the front wheel bearing hub

To squeeze the hub assembly from the steering knuckle special tool is required, and therefore, the node should be delivered to the assembly in a workshop service center, where the replacement of worn-out wheel bearing will be made by qualified experts. Description of the procedures for removing and installing a fist described in Section Removal and installation of assemblage of a rotary fist with a nave.

« previos page
Removal and installation of assemblage of a rotary fist with a nave

next page »
Removing and installing front stabilizer bar