1. Disconnect from the battery at first a negative wire, then positive. | If installed on the car stereo is equipped with a security code before to disconnect the battery make sure that have a correct combination for audiosystem input in action! Before embarking on the steering wheel is deified at least 10 minutes. |
2. Bring the front wheels in the straight-ahead position. | 3. Remove the small cover access hole in the side of the column cover and disconnect the wiring from the airbag module. |
4. Having hooked a small screwdriver, remove the decorative cap screws securing the airbag module. The screws have a head of type TORX and covered with a special fixing structure, and therefore, when you install the module in place must be replaced without fail. Remove the airbag module of the hub of the steering wheel. | Avoid turning the airbag module face to itself, as its casual operation is fraught with major injury (see chap. Onboard electric equipment). |
5. Give the nut of the steering wheel, and then mark the position of the latter relative to the hub of the steering shaft - such labeling may already have occurred. 6. Disconnect the wiring Tempostat. | 7. Using a special puller, remove the wheel from the shaft of the steering column. | In no case do not bring down the wheel from the shaft with a hammer, after removing the wheels do not turn the steering shaft! |
|
| 8. If necessary, check the status or replacing shift paddles remove spring contact assembly. | Whether because spring contact will be removed or not, duct tape, attach the central portion of its hub to the outer ring so as to completely eliminate the possibility of its rotation. Avoid turning the steering shaft when removing the steering wheel! |
|
9. If necessary, remove the fastening screws, release the latch, disconnect the wiring and remove the spring assembly in contact with the steering column. |