1. Loosen the wheel nuts. Poddomkratte back of the car and establish it on props. Remove the rear wheels. 2. On models equipped with ABS, remove the gauge of turns of the rear wheels. Remove the locking screws and release the sensor harnesses from the support brackets. 3. Disconnect the drive cables, and remove the parking brake calipers and brake disc (see chap. Brake System). Attach the slides to the rods helical springs. 4. If the rear axle must be replaced, remove the hub assembly with the wheel bearing (see. Section Removal and installation of assemblage of the rear hub with wheel bearing). 5. Poddomkratte rear axle jack under the middle one, or two at the ends. 6. Otboltite from the lower ends of the bridge shock absorbers (see. Section Removal, check of a condition and installation of the rear suspension struts). | 7. Remove transverse torque rods from the car chassis. |
| 8. Give nuts and remove the axle bolts trailing arm suspension. With the help of an assistant gently remove the rear axle assembly with the torque arms from under the car. |
9. Assess the jet bar bushings, rod and longitudinal control arms. Defective components replace. 10. Cross-reactive control rod from the rod can be removed from the assembly of the rear axle by releasing the appropriate fasteners. When installing the components in place, make sure that the bar appeared deployed marking the up-arrow, the control rod bushing facing the side with the smaller diameter hole in the bar. |