Replacing the wheel studs

1. Loosen the wheel nuts, Poddomkratte car and establish it on props. Remove a corresponding wheel.
2. Remove the brake disc / drum (see chap. Brake System).

3. Partially screw the nut on the stud to be replaced. Squeeze out the pin from the hub assembly flange using a special tool. 1 - The hub flange 2 - wheel nut 3 - Clamp

4. Thread the pin in the hub flange (on the reverse side of the latter), install spacer sleeve / multiple flat washers and screw the nut. 1 - The hub flange 2 - Spacer sleeve

5. Tighten the nut until the stud is not fully sit in the flange.
6. Replace the brake disc / drum. Lower the car to the ground and tighten the wheel nuts to the required torque (see chap. Adjustment and routine maintenance).